Luzhnetskaya embankment 10a

Daily, from 10 A.M. till 8 P.M. (GMT+3)

BMW G-Series

  • $219.00

Mileage Stopper for BMW G-series

This device is used to stop the odometer counter by directly blocking the mileage data from reaching the odometer. Works as CAN (Controller Area Network) module that is installed behind the dashboard.

Installation. The device is installed behind the dashboard by connecting it to the CAN plug of the dashboard on one end and the car cable on the other. Installation does not require any soldering or wire cutting and it can usually be done in 30 minutes. 

Activation. The device comes pre-activated (program 1 is pre-activated by default, see "Programs" below). The activation and deactivation of the mileage filter are done using the standard buttons found on the steering wheel. This way, you can quickly and easily manage the mileage blocker by yourself when you need it. The device is activated by pressing a single button on the steering wheel. Activation is confirmed by flashing the hazard light.  No need to reset. Once activated the device just works every time you start the engine. It can be activated and deactivated anytime-either parked or on the road.

Programs. To switch a mode, press and hold the "BC" button on the left lever for 10 seconds. Programs are switched successively. Program switching is confirmed by the flashing of a hazard light. The speedometer works according to the selected program. 

Known issues. Cruise control and all other assistance systems work accordingly. No error messages are displayed on the dashboard. After the uninstallation, the mileage stays the same.

Data sheet
Activation / ControlPush and hold "BC" button 10 sec.
Speedometer IndicatorDepends on dashboard
Oil ChangeStopped
Connection PointBehind the dashboard

Related Products